Configuring Bridging
110
EtherXtend User’s Guide
zSH>
bridge add 1-1-40-0/efmbond uplink
Adding bridge on 1-1-40-0/efmbond
Created bridge-interface-record 1-1-40-0-efmbond-0/bridge
To create a bridge path for the uplink enter,
bridge-path
add
interface/
type global
:
zSH>
bridge-path add 1-1-40-0-efmbond-0/bridge global
Bridge-path added successfully
3
To create a downlink bridge on the LAN interface, enter
bridge add
interface/type
downlink
VLAN 100:
zSH>
bridge add 1-1-1-0/eth downlink vlan 100
Adding bridge on 1-1-1-0/eth
Created bridge-interface-record 1-1-1-0-eth/bridge
4
To verify the bridges created, enter
bridge show
:
zSH>
bridge show
Typ VLAN Bridge St Table Data
---------------------------------------------------------------------------------
dwn 123 1-1-4-0-eth/bridge UP D 00:13:72:de:92:2e
D 00:1a:6d:13:19:8f
S VLAN 123 default [U: 3600 sec,
M: 150 sec, I: 0 sec]
upl Tagged 1-1-40-0-efmbond-0/bridge UP S Global default [U: 3600 sec,
M: 150 sec, I: 0 sec]
dwn 100 1-1-1-0-eth/bridge DWN
EtherXtend CO mode with subtended EtherXtends in CPE mode
EtherXtend configurations can bridge together devices in both CO mode and
CPE mode.
Configure the EtherXtend in CO mode
The EtherXtend can be configured in CO mode which uses an uplink bridge
to the outside network and a downlink bridges to subtended EtherXtends in
CPE mode.
shows one EtherXtend device in CO mode and two EtherXtend
devices configured in CPE mode. The EtherXtend CPE 1 uses a TLS bridge
with VLAN 100 to connect the WAN to the LAN. The EtherXtend CPE 2 also
uses a TLS bridge with VLAN 200 to connect the WAN to the LAN.
Summary of Contents for EtherXtend 3300 Series
