EtherXtend bridge commands
EtherXtend User’s Guide
113
Creating TLS bridges on the EtherXtend CPE 2
When using TLS bridges on a device, both the WAN port and the LAN port
must use TLS bridges.
1
To find the bond group number on the WAN, enter the
bond show all
:
zSH>
bond show all
Bond Groups
Slot GrpId Name Type State
1 40
1-1-40-0 efmbond ACT
2
To create a TLS bridge interface on the WAN port using the bond group
number, enter
bridge add
interface/type
tls
:
zSH>
bridge add 1-1-40-0-efmbond-0/bridge tls
3
To create a TLS bridge interface on the LAN port to the business, enter
bridge add
interface/type tls
:
zSH>
bridge add 1-1-1-0-eth/bridge tls
4
To verify the bridges created, enter
bridge show:
fm1>
bridge show
Typ VLAN Bridge St Table Data
---------------------------------------------------------------------------------
tls 0 1-1-1-0-eth/bridge UP
tls 0 1-1-40-0-efmbond/bridge UP
EtherXtend bridge commands
The EtherXtend supports the following
bridge
commands:
•
•
•
Refer to the
Zhone CLI Reference Guide
for a detailed explanation of the
available
bridge
commands.
Bridge delete command
The
bridge delete
command deletes a specific bridge entry from the system.
zSH>
bridge delete 1-1-40-0-efmbond-0/bridge
1-1-40-0-efmbond-0/bridge Delete complete
Bridge show command
The
bridge show
command displays either a single bridge path entry or the
entire bridge table.
Summary of Contents for EtherXtend 3300 Series
