IP Service Level Agreement
132
EtherXtend User’s Guide
Figure 19: IPSLA
Configuring IPSLA
IPSLA requires the following configuration steps:
•
Set ipsla-global settings to enable device state and optionally set polling
interval
•
Create ICMP path between devices
•
Optionally modify COS actions for the desired COS queues
•
Optionally modify COS map for Diff Server Control Point (DSCP)
mappings
To configure IPSLA:
IPSLA global parameters shown in
determine if the feature is active,
and if globally enabled, determine the time interval between outgoing IPSLA
Pings.
1
Enable IPSLA and set IPSLA ping interval.
a
View the global IPSLA settings by entering
ipsla show global.
zSH>
ipsla show global
state: -------> {disabled}
pollSeconds: -> {60}
The polling interval (60 to 3600 seconds) is used for real-time and
historical statistics.
MALC as IPSLA
Initiator
EtherXtend as IPSLA
Responder
IPSLA Path for
ICMP Pings
MALC as IPSLA
Responder
IP Network
IPSLA Path for ICMP Pings
EtherXtend as IPSLA
Responder
IPSLA Path for
ICMP Pings
Table 22: IPSLA global
Parameter
Value
Description
state
enabled/disables
IPSLA global feature activity
pollseconds
60...3600
The interval between outgoing IPSLA pings in seconds.
Summary of Contents for EtherXtend 3300 Series
