EtherXtend Installation
42
EtherXtend User’s Guide
For the best connection results, the remote device should be set to
autonegotiate speed and duplex mode as well. If the remote device cannot be
configured to autonegotiate, speed may be hard set at either 10 Mbps or 100
Mbps. But duplex mode must be hard set to half duplex. A 10/100 Ethernet
connection will not operate properly if the remote device is hard set to full
duplex.
Hard setting the speed and mode of an Ethernet port
In order to manually provision the speed and duplex of the Ethernet port, the
autonegstatus must be set to disabled and any of the following values entered
in the mauType field:
To change the speed and mode of the Ethernet port, enter the following
commands:
1
To view the Ethernet port interfaces, enter
list ether
:
zSH>
list ether
ether 1-1-1-0/eth
ether 1-1-2-0/eth
ether 1-1-3-0/eth
ether 1-1-4-0/eth
4 entries found.
2
To view the Ethernet port interface parameter defaults, enter
get ether
interface/type
:
zSH>
get ether 1-1-1-0/eth
ether 1-1-1-0/eth
autonegstatus: ----> {enabled}
mauType: ----------> {mau100basetxfd}
restart: ----------> {norestart}
ifType: -----------> {mau100basetxfd}
autonegcap: -------> {bb10b10b100baseTXFD}
remotefault: ------> {noerror}
clksrc: -----------> {automatic}
pauseFlowControl: -> {disabled}
3
To view the ether port interface parameter variables, enter
show ether
:
Table 12: mauType field values
mauType
Setting
mauType = mau10basethd
10 Mbps half-duplex
mauType = mau10basetfd
10 Mbps full-duplex
mauType = mau100basetxhd
100 Mbps half-duplex
mauType = mau100basetxfd
100 Mbps full-duplex
Summary of Contents for EtherXtend 3300 Series
