Bridging behavior for untagged, tagged, and s-tagged
EtherXtend User’s Guide
91
Untagged bridging examples
Configuring untagged or transparent bridging allows traffic to be forwarded
from a downlink interface through the EtherXtend uplink interface based on
the destination MAC address without tagging or modification to the frame.
Refer to the
Zhone CLI Reference Guide
for a complete description of the
command options and syntax.
Note:
Ethernet interfaces can be addressed as either
eth
or
ethernetcsmacd
. The
eth
abbreviation is used in command output.
Configuring an untagged bridge
To add an untagged bridge:
1
To add an untagged bridge to the upstream SHDSL interface, enter
bridge
add
interface/type:
zSH>
bridge add 1-1-40-0/efmbond
Adding bridge on 1-1-40-0/efmbond
Created bridge-interface-record 1-1-40-0-efmbond-0/bridge
This example adds a default transparent bridge interface to the SHDSL
card on the MALC and sets the parameters to the default transparent
bridge interface settings.
The following example shows the default
bridge-interface-record
settings defaults. It is recommended not to change the default settings
unless advanced bridge configuration is required. To view the defaults,
enter
get bridge-interface-record
interface/type
:
zSH>
get bridge-interface-record 1-1-40-0-efmbond-0/bridge
bridge-interface-record 1-1-40-0-efmbond-0/bridge
vpi: ---------------------------------> {0}
vci: ---------------------------------> {0}
vlanId: ------------------------------> {0}
stripAndInsert: ----------------------> {false}
customARP: ---------------------------> {true}
filterBroadcast: ---------------------> {true}
learnIp: -----------------------------> {false}
learnUnicast: ------------------------> {false}
maxUnicast: --------------------------> {0}
learnMulticast: ----------------------> {false}
forwardToUnicast: --------------------> {true}
forwardToMulticast: ------------------> {true}
forwardToDefault: --------------------> {false}
bridgeIfCustomDHCP: ------------------> {true}
bridgeIfIngressPacketRuleGroupIndex: -> {0}
vlanIdCOS: ---------------------------> {0}
outgoingCOSOption: -------------------> {disable}
outgoingCOSValue: --------------------> {0}
s-tagTPID: ---------------------------> {0x8100}
s-tagId: -----------------------------> {0}
Summary of Contents for EtherXtend 3300 Series
