46
SkyZhone 1600, 1400, 1200 Hardware Install Guide
FCC RF Exposure Requirements (per OET-65) requires the SkyZhone platform to
be mounted such that the general public does not come within 10 inches of the
antennae.
__________________________________________________________________
Caution:
•
This product requires professional installation.
•
The unit is sealed at the factory and must not be opened in the field. The unit shall be
returned to the factory for repairs.
•
The PoE (Power over Ethernet) connector sources power to other devices. Some
devices may not be compatible with this feature. In that case, do not connect the
wires that supply the power. The power is 48 volts DC, at a maximum of 5 watts.
__________________________________________________________________
Note:
•
This equipment has been tested and found to comply with the limits for a Class C
digital device, pursuant to part 15, subpart C, of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance
with the user manual, may increase the potential for harmful interference to radio
communications.
•
This warning applies to the Skyzhone-1400 and SkyZhone-1600 only. This
equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which the
user will be required to correct the interference at their own expense.
•
The supplied cables and antennae must be used to ensure compliance with Part 15,
FCC Rules. The use of any other antennas will invalidate the unit's FCC Part 15
certification.
•
The 2.4 GHz band has been designed to operate with the antennae listed below, and
having a maximum gain of 5 dBi. Antennae not included in this list (Comet Part
Number CFA-245W-SR) or having a gain greater than 5 dBi are strictly prohibited
for use with this device. The required antenna impedance is 50 ohms.
•
The 4.9 GHz band has been designed to operate with the antennae listed below, and
having a maximum gain of 5.3 dBi. Antennae not included in this list (Comet Part
Number SF-D49NW-SR) or having a gain greater than 5.3 dBi are strictly prohibited
for use with this device. The required antenna impedance is 50 ohms
