CLI diagnostic methods
Z-Edge 64 Configuration Guide
99
Line LEDs
Z-Edge 64 BH2A (ISDN BRI)
The Line LEDS (1 - 4) will light continuously green when the ISDN D
channel is established. The Line LED will be off when there is no ISDN D
channel.
Z-Edge 64 H2A (POTS)
The Line LEDS (1 - 4) will light continuously green when the phone is
off-hook. The Line LED will be off when the phone is on-hook.
CLI diagnostic methods
Several diagnostic commands can be executed using the CLI, including the
showlinestatus, interface show, and traceroute commands.
showlinestatus command
The showlinestatus command uses this syntax:
showlinestatus shelf slot port subport
You can display status of individual lines on the Z-Edge 64 by entering values
for shelf, slot, and port.
zSH> showlinestatus 1 1 1
Search in progress .........
.................
GroupId --------> 4
Status ---------> ACTIVE (1)
TxClk ----------> NONE (1)
RefClkSrc ------> NO
If_index -------> 3
Peer If_Index --> 0
Shelf ----------> 1
Slot -----------> 1
Port -----------> 1
SubPort --------> 0
Display the status of all lines (or physical interfaces) connecting to the
Z-Edge 64 by entering showlinestatus only, or by specifying only shelf and
slot:
zSH> showlinestatus 1 1
Search in progress .........
.................
GroupId --------> 6
Status ---------> ACTIVE (1)
TxClk ----------> NONE (1)
