Deployment scenarios
zNID 24xx Series Configuration Guide
187
d
Set the PPP username, password and authentication method
In the
Username
,
Password
,
Service Name
and
Retry Interval
text
boxes enter the information supplied by your ISP.
In the
Authentication
dropdown select
Auto
, or the option requested
by your ISP.
4
Adjust LAN settings
For PPPoE connections the LAN side you define the IP address of the
interface and the subnet using DHCP (by default).
a
From the
Interfaces | PPPoE
page enter a check in the select column
for eth4.v404, then click
Edit Selected Interface
b
In the
IP Address
text box below
IP Configuration
enter an IP
address (192.168.102.1) and in the
Subnet Mask
define the mask for
the subnet (255.255.255.0)
c
From the
DHCP Server
dropdown below
Client Addressing
select
Enable
.
Figure 148: Defining the subnet for the PPPoE bridged VLAN
d
In the
Subnet Range Start Address
text box enter a start address for
the subnet (192.168.102.10)
e
In the
Stop Address
text box enter an ending address for the subnet
range (192.168.102.100)
f
In the
Lease Duration (sec)
text box enter 86400.
86400 is 24 hours (in seconds, 60 x 60 x 24)
5
Configure Wireless (Wireless connections only)
Set port membership, authentication and encryption features as well as
other wireless options. See
Summary of Contents for zNID-GE-2402
