Specifications
Voltage:
220-240 V~50 Hz
Soldering iron:
24 V, 60 W
Hot air pump:
300 W
Temperature range:
50-480°C (soldering iron)
100-500°C (hot air pump)
Operation
Place the soldering iron /hot air pump in the holder separately. Then connect the
plug to the receptacle on the station and turn clockwise to tighten the plug nut.
Check that the power supply is corresponding to the specification on the type plate
and the power switch is on the “OFF” position. Connect the control unit to the power
supply and switch on the power. Then a self-test is carried out in which all display
elements are switched on briefly. The electronic system then switches on
automatically to the set temperature and displays this value.
The display and temperature setting
1. Press the button “+” or “-“ to adjust the temperature.
In short press, the set-point will change ±1°C
In long press, the set-point will change quickly and reach your target temperature.
2. “°C/°F" is the transfer button between °C/°F
The default unit is °C, press the "°C/°F” button to make change between °C and °F.
3. The air flow rate can be adjusted by the knob
When you rotate the knob to the LOW side, the air flow slows down;
When you rotate the knob to the HI side, the air flow goes up;
4. This item has sleep function.
When you put the air pump on the racket, the item will stop heating,
And the display shows “SLP” (means SLEEP), when you pick up the air pump, the
item will immediately get back to the set temperature.
5. Please note: “EEE” in soldering iron OSD means the soldering iron does not heat,
and not at work.
