LEVELING THE RANGE
The range must be level to obtain proper operation. The four screw-
type leveling legs located on the corners at the bottom of range
should be adjusted by turning them clockwise to make the range
higher or counter-clockwise to lower the range until the range is
level. Use a level on surface units to check the leveling of the range.
ANTI-TIP BRACKET INSTALLATION
To reduce the risk of tipping the range by abnormal usage or improper door loading, the range
must be secured by properly installing the anti-tip device packed with the appliance.
•
Place the anti-tip bracket on the floor as shown in the figure below. The anti-tip bracket can
be installed on either the right or left side.
•
Mark the locations of the two holes of anti-tip bracket on the floor.
•
Use a 5/16” masonry drill bit and insert plastic anchor.
•
Secure bracket to the floor using screws.
•
Slide appliance into position.
NOTE:
If range is relocated, the bracket must be removed and installed in the new location.
13
