Press the
button
M
and then the TIMER key
P
immediately after that.
The TIMER light and the information display
L
will start blinking.
Use the adjustment keys
O
to set the time at which the heater must ignite.
Use the key (
N
hour) to set the hours and the key (
M
min.) to set the minutes
(interval of 5 minutes).
After approximately 10 seconds the information display will show CLOCK
again and the TIMER indicator light will light up, indicating that the timer
function has been activated (Fig. H).
The timer will ensure that the room will have been heated to approximately
the required temperature at the set time.
When you want to switch off the heater and ignite it again with the timer, all
you have to do is press the TIMER key (refer to Section G).
Press the
button
M
once to clear the timer setting.
If you would like more extensive timer possibilities, we advise you to procure
the Zibro weektimer. This timer is easy to connect with your Zibro Heater, see
T
.
G
SWITCHING OFF THE HEATER
There are two ways to switch off the heater.
Press the
button
M
. The information display will show the CLOCK
signal. Within approximately one minute the flame will have extinguished.
Press the TIMER key
P
, when you want to switch off the heater and ignite it
again with the timer the next time. This not only switches off the heater, but
it also activates the timer function. You can change the required time with the
adjustment keys
O
(refer to Section F).
H
THE INFORMATION DISPLAY
The information display
L
not only serves as an indicator of the (set) time and
temperature (Sections C, E, and F), it also indicates any malfunctioning of the
heater. The code on the information display tells you what is the matter:
CODE
INFORMATION
WHAT TO DO
e - 0
Temperature within the heater too high.
Cool-down and re-ignite.
f - 0
Power interrupted.
Re-ignite the heater.
e - 1
Faulty thermostat.
Contact your dealer.
f - 1
Faulty burner thermistor.
Contact your dealer.
e - 2
Starting problems.
Contact your dealer.
e - 5
Tipping-over protection.
Re-ignite the heater.
e - 6
Poor burning.
Contact your dealer.
e - 7
Room temperature
If necessary,
above 32°C.
re-ignite the heater.
e - 8
Defective booster.
Contact your dealer.
e - 9
Air filter dirty; or
Clean filter
Fuel pump dirty.
Contact your dealer.
2
1
4
3
2
1
4
55
H: The TIMER indicator
light indicates that the
timer function has been
switched on.
☞
☞
In case of any
malfunctioning the
information display will
tell you what is the
matter.
