14
1.
Insert the black test lead banana plug into the
negative
COM
jack and the red test lead banana
plug into the positive diode jack.
2.
Turn the rotary switch to the
/
•)))
position.
3.
Touch the test probes to the diode under test.
Forward voltage will indicate 400 to 700mV.
Reverse voltage will indicate “
I
”. Shorted devices
will indicate near 0mV. Shorted devices will
indicate near 0mV and an open device will
indicate “
I
” in both polarities.
TEMPERATURE MEASUREMENTS
WARNING:
To avoid electric shock, disconnect both test
probes from any source of voltage before making a
temperature measurement.
1. If you wish to measure temperature in
o
F, set the function
switch to the
o
F range. If you wish to measure
temperature in
o
C, set the function switch to the
o
C range.
2. Insert the type K thermocouple probe black test lead
banana plug into the negative
COM
jack and the red test
lead banana plug into the positive
Temp
jack..
3. Touch the Temperature Probe head to the part whose
temperature you wish to measure. Keep the probe
touching the part under test until the reading stabilizes
(about 30 seconds).
4. Read the temperature in the display. The digital reading
will indicate the proper decimal point and value.
WARNING:
To avoid electric shock, be sure the
thermocouple has been removed before changing to
another measurement function.
