N
Flash BIOS
The Mainboard flash BIOS provides users with more flexibility
in upgrading their mainboards. The flash BIOS can be easily
reprogrammed via software.
O
Floppy Drive Connector
The Mainboard provides a 34-pin connector that supports
the included floppy drive ribbon cable. After connecting the
single end to the on-board “FLOPPY” connector, connect
the remaining plugs on the other end of the cable to the
corresponding floppy drives.
NOTE: Pin 5 is removed to prevent inserting the connector in
the wrong orientation.
P
IDE Device Connector
The Mainboard provides (2) independent bus-mastering PCI
IDE interfaces capable of supporting up to Mode 4 and Ultra
DMA-33/66/100 devices. The system BIOS supports automatic
detection of the IDE device data transfer rate and translation
between different kinds of device modes such as Logical Block
Addressing (LBA), Extended Cylinder Sector Head (ECSH)
translation modes and ATAPI (e.g., CD-ROM) devices on both
IDE interfaces.
The two on-board IDE connectors support the provided 40/80pin
IDE hard disk ribbon cables. After connect the single end to
the mainboard connector, connect the two remaining plugs at
the other end of your hard disk(s) and/or CD-ROM drive(s).
If you install two hard disks and/or CD-Rom drives, you must
configure the two drives by setting their IDE master/slave
jumpers according to the documentation for those devices.
Also, you may connect the two hard disk drives so that both
become Masters, using one ribbon cable on the primary IDE
connector and one on the secondary IDE connector.
Page 42
Mainboard User's Manual
Summary of Contents for TX-PLE
Page 4: ......
Page 9: ...Mainboard User s Manual Page 9 Installation Mainboard Diagram ...
Page 17: ...BIOS Setup ...
Page 37: ...Glossary ...