Leak Testing
Naked flames (matches or other open flames) must not be used to check for leaks. This is
a dangerous practice which must be avoided.
IF YOU SMELL GAS!
•
Immediately isolate the gas supply by turning the gas off at the bottle.
•
Extinguish all naked flames.
•
Do not operate any electrical devices close to the barbeque.
•
Check for leaks as described below.
•
Ensure that local area is well ventilated to remove any excess gas.
•
If the gas smell continues the barbeque should not be operated under any
circumstances and it is important to immediately turn off gas supply and contact
the after sales support provider help line mentioned towards the back of this manual.
•
Before proceeding, it is important that you leak test the barbeque. Make sure the
barbeque control knob is OFF.
Leak Tests Must be Carried Out in a Well Ventilated Area!
If you have a portable gas cylinder, turn the cylinder ON by rotating the knob anti-clockwise. If you
have a wall connection, ensure the bayonet fitting is connected and supply valve open. Spray or
pour soapy water (about the same concentration as washing up water) along the gas line including:
•
The gas connection at the inlet of the barbeque, hose connections and regulator
connections.
•
The gas hose or copper piping, including any joints, valve connections or bends in
the piping, and the gas connection at the gas cylinder or the wall connection.
•
If bubbles appear, there is a gas leak.
•
If the leak is at a connection, check and retighten all gas connections and joints
and retest. If the leak is anywhere else, or if you cannot resolve the leak, do not
proceed. Immediately turn the gas supply
OFF
at the source and contact your
local Barbeques Galore store. If you have a bayonet connection, turn the supply
valve
OFF
, remove the hose from the wall or floor fitting and contact your local
Barbeques Galore store.
You can also check for leaks using a Gas Safety Gauge, available at your Barbeques
Galore store. This provides an easier and more convenient way to check for leaks.
•
After performing the soapy water test, please ensure the fittings are rinsed
thoroughly with clean water.
It is Recommended that a Leak Test be Carried Out on an Annual Basis.
Check Cylinder Connection Every Time you Refill or Exchange Cylinders.
11
