2.5 Requirements placed on the personnel / due diligence
Persons entrusted with the planning, installation, commissioning and maintenance and
servicing in connection with the frequency inverter must have the corresponding qual-
i
fi
cations and skills for these jobs.
In addition, they must be knowledgeable about the safety regulations, directives, rules
for the prevention of accidents and the corresponding national as well as regional and in-
house regulations. Personnel to be trained or instructed and apprentices are only
permitted to work on the device under the supervision of an experienced person. This
also applies to personnel undergoing general training. Comply with the legal minimum
age.
2.6 Work on the device
Info
Mounting, electrical connection, and start-up operation may only be carried out by an
electrical specialist in accordance with electrotechnical regulations (e.g. EN 50110 or
EN 60204)!
Danger due to electric current
•
It is generally forbidden to carry out work on electrical live parts!
•
The 5 electrical safety rules must be observed!
•
The safe isolation from the supply must be checked using a
two-pole
voltage
detector.
•
Opening of motor is prohibited. Loosening the screws will void the warranty!
•
Any faults detected in the electric system/modules/operating equipment must be
corrected immediately. If these faults are not corrected, the device/system is
potentially very dangerous. The device/system must therefore not be operated when it
is faulty.
•
Fuses must always be only replaced; never repaired or bridged. The speci
fi
cations for
the maximum series fuse must always be adhered to (
Technical data). Only fuses
cited in the electrical circuit diagram may be used.
Attention, automatic restart!
•
The motor may switch on and o
ff
automatically for functional reasons.
•
Automatically restart after a power failure or mains disconnection!
•
Wait until the motor has stopped before approaching.
Danger of being sucked in!
Do not wear loose or hanging clothing, jewellery, etc., tie together long hair and cover it.
2.7 Modi
fi
cations / interventions in the device
Attention!
For reasons of safety, no unauthorized interventions or modi
fi
cations may be made on
the device. All planned modi
fi
cations must be authorized by the manufacturer in writing.
Assembly instructions
FE2owlet-ECQ
Safety instructions
L-BAL-F062-GB 2022/20 Index 004
Part.-No. 00702389-GB
7/24
