Output power
Output power display (display available depending on the software version)
Min. speed cut off
Momentarily status for minimum speed cut off
“
ON
”
= switch off, if Setpoint (+/-
“
Min. speed cut off
”
) is reached.
“
OFF
”
= no switch off that means operation with minimum rate of air.
9.9
Controller Setup
9.9.1
PIN protection activate, PIN0010
PIN Protection
The adjustments for the installation in the service level can be protected against
unintentional modi
fi
cations. To do this, activate the
“
PIN protection
”
=
“
ON
”
.
In order to simplify the initial start-up operation, the service level in the factory setting is
free =
“
OFF
”
i.e. accessible without
PIN 0010
.
Information
After installation of the device has been carried out,
“
PIN-Protection
”
should be activated =
“
ON
”
9.9.2
Set protection activate, PIN 1234
Set protection
The
“
Settings
”
menu for the user
’
s basic settings (Setpoint, default value, min, max ..)
are freely accessible when using the factory settings (i.e. without
“
PIN
”
).
If necessary, these can also be protected against unauthorized modi
fi
cations by using
a
“
PIN 1234
”
. For this, the settings protection must be programmed to
“
ON
”
. The
settings menu is then no longer visible without inputting a PIN!
Function only in combination with activated PIN-Protection!
9.9.3
Save user settings restore with PIN 9090
Save User Setup
The individually made device con
fi
gurations (User Setting) can be saved here (corre-
sponds to PIN 9091).
By entering
PIN 9090
the individually made device con
fi
gurations can be reestablished
(
Start - PIN Input).
Information
By entering
“
PIN 9095
”
in the
“
PIN
”
menu in the
“
start
”
menu-group, the device is entirely reset to the
pre-delivery condition.
Any changes that have been made to the settings are thus lost!
Operating Instructions
Fcontrol
–
model series FXDM
Programming
L-BAL-E072-GB 1642 Index 008
Part.-No.
53/105
