8.2
Cleaning
Danger due to electric current
Voltage supply for fan must be interrupted and secured against restoration!
Clean the fans`s
fl
ow area.
Attention!
•
Do not use any aggressive, paint solvent cleaning agents when cleaning.
•
Make sure that no water gets inside the motor and the electronics (e.g. by direct contact with seals
or motor openings), observe protection class (IP).
•
The drain holes (if available) corresponding to the installation position must be checked for free
passage.
•
In case of improper cleaning work, no warranty is assumed regarding corrosion formation / paint
adhesion for unpainted / painted fans.
•
To avoid accumulation of moisture in the motor, the fan must be operated for at least 1 hour at 80%
to 100 % of the maximum speed before the cleaning process!
•
After the cleaning process, the fan must be operated for at least 2 hours at 80 to 100 % of the
maximum speed for drying purposes!
9
Enclosure
9.1
Technical data
Frequency inverter line Voltage
(
Rating plate)
3 ~ 380...480 V, 50/60 Hz
(Output data relates to an inverter voltage of 400 V)
Permissible minimal and maximal am-
bient temperature for operation
-20...40
°
C
rating plate
Please see the technical documentation of the product for the minimum and maximum
ambient temperature valid for the respective fan ; these may deviate from the speci
fi
ed
permissible ambient temperatures.
To avoid condensation the drive must be continuously energized due to the application
of heat, with interruptions such that cooling to the point of condensation does not occur.
Max. permissible installation height
above amsl
No limitation up to 1000 m
Above 1000 m up to max. 4000 m only after consulting with the manufacturer
Permissible rel. humidity
The motor is released for a relative humidity of 80 % at continental climate without
other ambient in
fl
uences. Other ambient conditions on request.
Permissible temperature range for
storage and transport
-30...+50
°
C
Max. cross section/diameter of the
conductors for connection
Conductor cross section single-wire: 4 mm
2
Conductor cross-section
fi
ne-wire: 4 mm
2
, with wire end ferrule 2.5 mm
2
Conductor (AWG): 12
dB(A) values
product catalog
Ball bearings grease service-life (F
10h
) during standard usage ca. 30 - 40,000 h
Protection rating
IP55
Assembly instructions
PMblue
Enclosure
L-BAL-F073-GB 2033 Index 003
Part.-No. 00703805-GB
17/22
