1 General notes
Compliance with the following instructions is mandatory to ensure the functionality and
safety of the product. If the following instructions given especially but not limited for
general safety, transport, storage, mounting, operating conditions, start-up, mainte-
nance, repair, cleaning and disposal / recycling are not observed, the product may not
operate safely and may cause a hazard to the life and limb of users and third parties.
Deviations from the following requirements may therefore lead both to the loss of the
statutory material defect liability rights and to the liability of the buyer for the product that
has become unsafe due to the deviation from the speci
fi
cations.
1.1 Structure of the operating instructions
Before installation and start-up, read this manual carefully to ensure correct use!
We emphasize that these operating instructions apply to speci
fi
c units only, and are in
no way valid for the complete system!
Use these operating instructions to work safely with and on the device. They contain
safety instructions that must be complied with as well as information that is required for
failure-free operation of the device.
Keep these operating instructions together with the device. It must be ensured that all
persons that are to work on the device can refer to the operating instructions at any time.
1.2 Exclusion of liability
To allow for future developments, construction methods and technical data given are
subject to alteration. We do not accept any liability for possible errors or omissions in the
information contained in data, illustrations or drawings provided.
We accept no liability for damage caused by misuse, incorrect use, improper use or as a
consequence of unauthorized repairs or modi
fi
cations.
2 Safety instructions
•
Installation, electrical connection and commissioning to be carried out by trained
service personnel only. The speci
fi
cations of the manufacturer or supplier, and
instructions relating to the equipment, should be rigidly adhered to. Failure to comply
with these conditions will invalidate the guarantee on our controllers and accessories!
•
The 5 electrical safety rules must be observed!
•
It is strictly forbidden for work to be carried out on any components while they are
connected to live voltage. The open equipment is protected to IP00. It is possible to
come into direct contact with dangerous voltages!
•
The safe isolation from the supply must be checked using a
two-pole
voltage
detector.
•
Cover neighbouring electrical equipment during installation work.
•
During operation, the device must be closed or installed in a control cabinet. Fuses
may only be replaced by new ones and must not be repaired or bypassed. The data
for the maximum line fuse are to be considered absolutely (see Technical data). Use
only fuses speci
fi
ed in schematic diagrams.
•
Never clean electrical equipment with water or similar liquids.
Operating Instructions
S-ET... / S-DT...
General notes
L-BAL-E058-GB 1931 Index 002
Part.-No.
3/12
