3.5 Disposal / recycling
Disposal must be carried out professionally and in an environmentally friendly way in
accordance with the respective national legal stipulations.
"
Separate the materials by type and in an environmentally friendly way.
"
If necessary, commission a specialist company with the waste disposal.
4 Installation
4.1 General notes
Attention!
Mounting, electrical connection, and start-up operation may only be carried out by an
electrical specialist in accordance with electrotechnical regulations (e.g. EN 50110,
EN 60204, IEC 364)!
•
The 5 electrical safety rules must be observed!
•
Cover neighbouring electrical equipment during installation work.
•
Before installation remove the device from the packing and check for any possible
shipping damage! Start-up is not allowed in the case of transport damage!
•
At a weight greater than 25 kg for men / 10 kg for women, the device should be lifted
out by two persons (according to REFA). The values may differ from country to
country.
•
Wear safety shoes and gloves for handling!
•
Assemble the device on a clean and stable base. Do not distort during assembly! Use
the appropriate mounting devices for proper installation of the unit!
•
Do not mount equipment on vibrating base!
•
Do not allow drilling chips, screws and other foreign bodies to reach the device
interior!
•
The device should be installed in a location where it will not be disturbed, but at the
same time can be easily accessed!
•
Depending on the housing model use supplied stoppers for cable inlets, cut off
necessary cable inlets respectively to the cable diameter. Or alternative use cable
inlet for cable glands. Any cable ducts openings not used must be sealed!
•
The required protective earth connection is established using screws between the
housing parts in metal terminal space covers and housing casings. Commissioning is
only permissible after these screws have been properly attached!
•
Metal screwed-connections are not permitted in plastic housing parts because there
is no potential equalization.
•
Care must be taken to avoid direct radiation from the sun!
•
The device is designed for vertical installation (bottom cable inlet). A horizontal or
reclined installation is only permissible after technical release of the manufacturer!
•
Be sure to observe proper heat dissipation (see Technical data, heat dissipation).
Operating Instructions
S-ET... / S-DT...
Installation
L-BAL-E058-GB 1931 Index 002
Part.-No.
6/12
