2
Introduction
1
The LED Lighting Driver allows you to remotely control your lightings as
well as automate using schedules.
This guide will provide you with an overview of the product and help you
get through the initial setup and installation.
SMART LED DRIVER
INPUT : 100-240VAC 0.40A 50/60Hz
OUTPUT : 24-38VDC Max 950mA
Max current can be set by app
SEC wire prep
0.5 -1.5mm²
8 - 9mm
PRI wire prep.
0.75mm²
Class 2 Power Supply
N
L
W -
C -
V +
GND
0 -10V +
0 - 10V
Input
Output
AC In
Get started
2
Warning!
• The LED Lighting Driver must be installed and serviced only by qualified
electrical personnel.
• Do not touch the terminals of the device during testing.
• Turn off all power supplying this equipment before installing.
• Make sure that the power supply is off before connecting or disconnecting
it to the auxiliary device.
• Always use a properly rated voltage sensing device to confirm power is off.
• Replace all devices, doors and covers before turning on power to this
equipment.
Failure to follow these instructions will result in death or serious injury.
