2
J
J
o
o
i
i
n
n
i
i
n
n
g
g
t
t
h
h
e
e
Z
Z
i
i
g
g
B
B
e
e
e
e
N
N
e
e
t
t
w
w
o
o
r
r
k
k
As a ZigBee device, the Shutter Control needs to join a ZigBee network to receive commands. Please
follow the steps bellow to join the Shutter Control into a ZigBee network.
1. Connect the power cable to AC Input connector on Shutter Control.
2. Press and hold the function button for 10 seconds as the Shutter Control resets and starts searching for
existing ZigBee network. Please make sure the permit-to-join feature on the router or coordinator of
your ZigBee network is enabled.
3. If the Shutter Control successfully joins a ZigBee network, the LED Indicator will flash twice to confirm.
4. After joining the ZigBee network, the Shutter Control will be registered in the network automatically.
Please check the ZigBee network coordinator, system control panel or CIE (Control and Indicating
Equipment) to confirm if joining and registration is successful.
5. After joining the ZigBee network, if the Shutter Control loses connection to the current ZigBee network,
the LED indicator will flash every 20 minutes. Please check your ZigBee network condition and Shutter
Control signal range to correct the condition.
Removing Device from ZigBee Network (Factory Reset)
To remove the Shutter Control from current ZigBee network, the Shutter Control must be put to Factory
Reset to complete device removal. Factory Reset function will clear the Shutter Control of its stored setting
information and prompt the device to search for new ZigBee network.
Before removing device, make sure the Shutter Control is within current ZigBee network signal
range
1. Press and hold the function button for 10 seconds, then release the button to reset Shutter Control.
2. Upon reset, the Shutter Control will clear current ZigBee network setting and transmit signal to ZigBee
coordinator to remove itself from current ZigBee network. It will then actively search for available
ZigBee network again and join the network automatically.
Installation
Please use the recommended wire size of AWG 16-26 or Ø 1.31-0.129 (mm
²
).
Connect SCM according to the diagram below:
Connect L terminal of SCM to the L terminal of Power Supply.
Connect N terminal of SCM to the N terminal of Power Supply.
Connect O1 terminal of SCM to the Open terminal of the Shutter Motor.
Connect O2 terminal of SCM to the Close terminal of the Shutter Motor.
(Optional local switch)
Connect S1 and S2 terminals of SCM to the L terminal of Power Supply.
Operation
C
C
a
a
l
l
i
i
b
b
r
r
a
a
t
t
i
i
o
o
n
n
The Shutter Control default activation time is
4
minutes. When the Up/Down button is pressed or the
ZigBee network coordinator transmits Up/Down command, it will activate the Shutter Motor for 4
minutes.
For the Shutter Control to work properly, its activation time must be calibrated. There are two ways to
adjust the activation time:
ZigBee Command:
The activation time can be adjusted by sending command from the ZigBee
network coordinator. (See Appendix – Level Cluster Attribute – OnTransitionTime /
OffTransitionTime, minimum adjustable unit 100ms)
