16
The included IR remote control is used to switch between HDMI inputs.
The front panel of the SW-42Plus has a set of four LED indicators which are
associated with each input on the switch.
1. Point the IR remote control unit at the IR sensor on the front panel.
If an IR extender is being used, then both IR sensors will be used to receive IR signals.
2. Each numbered button on the IR remote control unit represents an input.
Press the desired source button on the IR remote control to switch to that input.
3. Press ON/OFF buttons to toggle between the operating modes. OFF will set the unit
in Stand-By mode. ON has two functions. If the unit is off (Stand-By mode) it will turn
on the unit. If the unit is turned on it will act as a Select button and toggle the
selection of the Outputs.
Using the IR Remote Control
Get
St
art
ed
