Handleiding Internet van Ziggo
86
them to your PCs, or use a method that involves you entering host names into
your PCs.
Note that in CM Mode, packets passing to the Internet to/from your PCs do not
travel through any of the IP stacks; instead they are directly bridged between the
WAN and LAN sides.
5.7
Residential Gateway (RG) Mode
figure 70:
Residential Gateway Mode
figure 71:
Three IP stacks are activated in cable modem mode
RG (Residential Gateway) Mode provides basic home networking plus NAT
(Network Address Translation). In this mode, three IP stacks are active:
1.
IP Stack 1 - for use by the cable company to communicate with the Cable
Modem section only. This stack receives its IP address from the cable
company during CM initialization. It uses the MAC address printed on the
label attached to the Wireless Cable Gateway.
2.
IP Stack 3 - for use by you to remotely (i.e. from somewhere on the WAN
side, such as at your remote workplace) communicate with the Cable
Modem and Networking sections, to remotely access the internal web page
Summary of Contents for Technicolor TC7210
