INSTRUCTION MANUAL
Semi-automatic BOV Filling Machine Z-2323
A0310.02.2323.905.1.EN
Page 19/39
6.
Adjustment of operating parameters of Z-2323
Adjustment of operating pressure
Following description applies to all pressure regulating valves installed in the device.
To increase the pressure on regulation valve, first enable the air supply by switching manual cut-off
valve located at the air preparation unit to the open position, then [Fig. 8]:
1.
Release the pressure regulator control knob by gently pulling it up (you will hear a
noticeable click);
2.
Turn the control knob clockwise, until the desired pressure appear on the pressure gauge;
The desired pressure value should always be reached from the bottom
(namely by increment). E.g. to decrease the operating pressure from 6 bar to
3 bar, first lower the pressure to 2 bar and then raise it to 3 bar.
3.
Lock control knob by gently pushing down (it clicks).
Fig. 8. Adjustment of operating pressure
NOTE! When adjusting the working pressure, observe the recommended
values given in pneumatic scheme attached to technical documentation.
Pressure regulation devices must be controlled once a year. More difficult
exploitation conditions require shorter intervals between controls. Pressure
regulators does not require maintenance and major repairs. If they have
experienced too much wear they are replaced with the new ones.
Summary of Contents for Z-2323
Page 42: ...PNEUMATIC DIAGRAMS ...
