13
10.4 Attaching the torque support arm
NOTICE
Non-compliance may result in material damage.
The torque support arm is designed so that lateral torques are not applied to the middle part with floating bearing.
►
Implement the torque support arm as shown.
Exchanging the standard torque support arm for a 2-point screw fitting in the middle part may damage the seals
and the inner electric slip ring system.
INFORMATION
The pin must be manufactured according to DIN ISO 2768-1, Table 1 "General tolerances for length
measurements."
►
Aim for manufacturing at the lower tolerance limit.
►
Calculate the pin diameter for the torque support arm using the dimensions from the dimensional drawing on
the data sheet.
34
2x
22
115
►
Arrange the pin of the torque support arm parallel to the turning axis
or casing surface of the product.
►
Maintain a parallelism tolerance of 0.1 mm.
A
0.1 A
►
Do not position the fixed point of the torque support arm onto the
product.
INSTALLATION AND OPERATING INSTRUCTIONS:
DVR1000
DDOC00221 / b
EN / 2021-11-11
Zimmer GmbH • Im Salmenkopf 5 •
77866 Rheinau, Germany •
+49 7844 9138 0 • www.zimmer-group.com
Summary of Contents for DVR1000 Series
Page 2: ......
