Operating Instructions
8.3 Performing the Treatment
8
Page 13
Note:
All buttons, menus and sub-menus can be activated directly on-screen with a
touch of your finger.
Program startup
Pressing the "Therapy" button on the home screen opens the therapy screen.
Selecting an
applicator
Choose the applicator to suit your desired therapy and screw it correctly into
the handpiece.
Applying the
handpiece /
applicator
Place the handpiece on the selected treatment point / area. In order to avoid
friction on the skin, en
Puls
lotion can be applied to the treatment area prior to
treatment when necessary.
Caution
!
When using lubricants, the applicator head must be covered using the silicone
protection cap.
Setting the pulse
energy
Set the pulse energy using the left controller.
Note:
enPulsPro offers two options for the pulse output.
Pulse emission with pre-set number of pulses
For pulse emission with pre-set number of pulses, the treatment is terminated
by the device after the pre-set number of pulses has been emitted.
The footswitch is deactivated and the emission of pulses is no longer possible.
Treatment can be continued by resetting the current pulse rate or by adjusting
the pre-set.
Pulse emission without pre-setting the number of pulses
With pulse output without pre-setting the number of pulses, the treatment is not
terminated by the device. Pulses are emitted as long as the footswitch is
activated.
For pulse emission without pre-set, only the ascending counting direction is
active.
Start of treatment
The treatment starts once the footswitch has been activated.
Note:
The pulse should only be activated via the footswitch once the handpiece has
been placed on the patient.
End of treatment
By de-activating the footswitch, the treatment is interrupted or terminated.
Note:
During therapy, the patient must be carefully monitored and, should problems
arise, therapy must be adjusted or stopped as necessary.
Summary of Contents for enPulsPro
Page 1: ...User Manual enPulsPro USA...
Page 2: ......
