INSTALLATION AND OPERATING INSTRUCTIONS:
2-jaw parallel gripper, electric, GEP2000 series
Zimmer GmbH
•
Im Salmenkopf 5
•
77866 Rheinau, Germany
•
+49 7844 9138 0
•
+49 7844 9138 80
•
www.zimmer-group.com
6
EN / 2021-07-08
DDOC01113-01 / a
6 Function
INFORMATION
Information about the function can be found in the standardized installation and operating instructions
(DDOC01113) or on our website.
Zimmer Customer Service is available to provide you with assistance if you have any further questions.
7 Installation
INFORMATION
Information about the installation can be found in the standardized installation and operating instructions
(DDOC01113) or on our website.
Zimmer Customer Service is available to provide you with assistance if you have any further questions.
7.1 Installing the power supply
INFORMATION
The cables that are used by Zimmer GmbH feature a minimum bending radius of 10 x the outer diameter.
This bending radius must not be undershot!
Freely suspended cables must be secured to prevent excessive motion loads or pinching.
►
Connect the supply cable to the product and the control system.
•
You can find the compatible power supply cable on our website at www.zimmer-group.com.
