43
20 Declaration of Incorporation
In terms of the EU Machinery Directive 2006/42/EC (Annex II 1 B)
Name and address of the manufacturer:
Zimmer GmbH
Im Salmenkopf
77866 Rheinau, Germany
+49 7844 9138 0
info@zimmer-group.com
www.zimmer-group.com
We hereby declare that the incomplete machine described below
Product designation:
2-jaw parallel gripper, electric
Type designation:
GEP2000IL-03 series
conform to the requirements of the Machinery Directive, 2006/42/EC, Article 2g, Annex VII.b – Annex II.b, in its design and
the version we put on the market.
Basic health and safety requirements:
Nr.1.1.2, Nr.1.1.3, Nr.1.1.5, Nr.1.3.2, Nr.1.3.4, Nr.1.3.7, Nr.1.5.3, Nr.1.5.4, Nr.1.5.8, Nr.1.6.4, Nr.1.7.1, Nr.1.7.4
A full list of applied standards can be obtained from the manufacturer.
We also declare that the specific technical documents were produced in accordance with Annex VII Part B of this Directive.
We undertake to provide the market supervisory bodies with electronic versions of special documents for the incomplete
machine through our documentation department, should they have reason to request them.
The incomplete machine may only be commissioned if it has been ascertained, if applicable, that the machine or
system in which the incomplete machine is to be installed satisfies the requirements of Directive 2006/42/EC on
Machinery and an EC Declaration of Conformity has been drawn up in accordance with Annex II 1 A.
Kurt Ross
Rheinau, Germany, 2020-11-15
Authorized representative for the
compilation of relevant technical
documents
(Place and date of issuance)
Martin Zimmer
(Legally binding signature)
Managing Partner
INSTALLATION AND OPERATING INSTRUCTIONS:
GEP2000IL-03
DDOC01219 / b
EN / 2021-12-20
Zimmer GmbH • Im Salmenkopf 5 •
77866 Rheinau, Germany •
+49 7844 9138 0 • www.zimmer-group.com
