3. Drill and chisel door
a. Drill 2-1/8” (54mm) hole through door face as marked for lock set (Figure 3a).
b. Drill 1” (25mm) hole in center of door edge for Latch Assembly (Figure 3b).
c. Insert Latch Assembly in hole keeping it parallel to face of door. Mark outline
and remove latch (Figure 3c).
d. Chisel 1/8” (3mm) deep or until latch face is flush with door edge (Figure 3d).
-3a-
-3b-
-3c-
-4a-
-4b-
-4c-
-4d-
-4e-
-3d-
a. Mark center hole on edge of jamb even with the center of the Latch Bolt on door edge (Figure 4a).
b. Drill a hole in door jamb on center mark. Check if the strike plate measure can perfectly fits in (Figure 4b).
c. Outline outside edges of Strike Plate (Figure 4c).
d. Chisel 1/8” (3mm) deep for Strike Plate or until flush (Figure 4d).
e. Install Strike Plate using two 3/4” (19mm) screws provided (Figure 4e).
4. Mark and drill door jamb
54mm
NOTE:
For drive in Latch, drill hole size indicated on template and press until it is flush with door edge.
5
25mm
Summary of Contents for VAULTA K1
Page 1: ...Electronic Door Knob ...
Page 8: ...7 ...
