X11 Wireless Broadband Router User manual
Page 55 of 69
Figure 47
6.7 Routing
If the Router is connected to more than one network, it may be necessary to set
up a static route between them. A static route is a pre-determined pathway that
network information must travel to reach a specific host or network.
Figure 48
z
Type / Target / Mask / Gateway
: Fill in these fields required by this
Static Routing function.
z
Add
: Fill in the all of the setting to be added and then click "Add". Then this
Special Application setting will be added into the "Current Routing Table"
below.
z
Current Routing Table
: This display shows the valid routing paths in
Broadband Router. User can view the information about current routing
paths
z
If you want to remove some route entries from the “Current Routing Table
", select the Route entry you want to remove in the table and then click
"Delete ".
6.8 NAT
Network Address Translation (NAT) allows multiple users at your local site to
access the Internet through a single Public IP Address. NAT provides Firewall
