3.
Commissioning
Unpacking
Remove the crate and check the compressor for damage, defect/missing parts etc.. In case of
damage through transport or a defect part, immediately contact your Zionair retailer.
Placement/installation of the compressor
When placing/installing the compressor, always keep into account the following things:
1.
Make sure there is enough free space around the compressor because of suction of air,
cooling and it is also easier when carrying out maintenance/repair jobs.
2.
Place the machine on a solid, level and clean surface.
3.
The place of installation has to be well-vented, well-lit and dry.
4.
Never use the compressor in the vicinity of explosive/inflammable substances and/or gases.
5.
Keep the place where the compressor is installed clean. Moist, dust and dirt have a negative
influence on both the efficiency and lifetime of the compressor.
6.
Place the air filter on the compressor.
Check before first use
1.
Check if all bolts and nuts are firmly tightened.
2.
Check the belt tension and the angle of the belt opposed to the compressor and motor, the
angle of the belt should be 90°, the belt must be able to move 10-15mm when pressed down
(refer to below picture).
PAY ATTENTION! Both too much tension and too less tension in the
belt are bad for the compressor!
3.
Check if all pipes look good and if there are no damages.
4.
Check the oil level, it should be upto the red dot in the
middle of the oil viewing glass (refer to picture on the right)
5.
Check if the electrical wiring is not damaged.
6.
Check the power supply and check if the power´s voltage is
correct.
7.
Whether the belt pulley is easy to rotate by hand.
8.
Pay attention to following points:
Is the earth wire connected correctly?
Carefully read the entire manual.
Don´t hit, knock or bend any pipes
Do not come near the fan with hands and clothes.
