8
Specific safety regulations for paint tank with spray gun
1.
Prevent breathing in paint at all times, wear respiratory protection at all times when one is
spray painting. Breathing in paint causes serious lung problems.
2.
Disconnect the device from the compressed air supply before cleaning it or performing
maintenance.
3.
The compressed air hose should be closable by means of a tap/valve and the compressed air
is to be free of water, oil and other pollutions.
4.
Check the machine previous to each use for damaged and/or defect parts. Pay special
attention if all seals are still good and check all hoses for leakages.
5.
At all times use your common sense when operating tools.
PAY ATTENTION! Failure to heed these instructions may cause damage to materials and/or
injuries!
3.
Assembly
Unpacking
Remove the carton and check the paint tank with spray gun for damage, defect parts etc.. In case of
damage through transport or defect parts, immediately contact your Zionair-retailer.
Assembly
1.
Install the pressure regulator onto the swivel adaptor on the tanklid. Check the bottom of the
regulator for the location of the tank connection.
2.
Install the lift handle in the threaded hole in the center of the tank lid, tighten the hex nut.
3.
Connect the air supply hose to the air inlet fitting on the tank pressure regulator.
4.
Attach the atomization air hose to the air outlet fitting on the tank pressure regulator
opposite to the air inlet fitting.
5.
Connect the material hose to the fluid outlet adaptor located on the tank lid.
4.
Operation
Instructions for the pressure regulator
The pressure regulator regulates the amount of pressure in the tank. This regulates the pressure of
the paint to the gun. Always start with a low tank pressure, for example 0 and set the pressure
gradually higher until the desired spray pattern is achieved. IMPORTANT! Before the connecting the
compressed air, close the pressure regulator of the tank by turning counterclockwise. Then connect
the compressed air and turn the pressure regulator gradually open to about 0.8 bar. Warning!
NEVER set the pressure higher than 3.4 bar!
