Page 10 of 16
Zip Hydroboil Electronic - Installation & Operating Instructions - 86584 - July 2008
DESCRIPTION
The Electronic Hydroboil has user interface that consists of a graphic LCD and 4 Capacitive Sensor Switches, (CSS). The
user interface gives the current status of the Hydroboil and allows the user to configure it as required.
Legend:
1 = ZIP Symbol
2 = Day of the Week indicator
3 = Setpoint Value
4 = CHANGE FILTER indicator
5 = ON indicator
6 = OFF indicator
7 = Sleep Symbol
8 = Sleep mode ( Stand by ) indicator
9 = Low light Symbol
10 = 24hour Clock
11 = BOILING WATER indicator
CSS1 = Capacitive Sensor Switch 1
CSS2 = Capacitive Sensor Switch 2
CSS3 = Capacitive Sensor Switch 3
CSS4 = Capacitive Sensor Switch 4
The LCD and capacitive sensor switches connect to the Controller PCB via a 4-way serial cable.
The DIP Switches on the Controller PCB should be configured as follows.
The Electronic Hydroboil has a real time clock that operates in 24 hour mode, and can have 2 ON-OFF times per day. If
the user selects either of the energy saver modes, (see below), ON-OFF mode cannot be used, (The user is not able to
access this part of the configuration). The real time clock is battery backed meaning the unit does not loose the
configuration data if power is removed.
The Hydroboil has two energy saver ( stand by ) modes that can be used in an either/or configuration. The energy saver
modes differ from on/off mode in that the water in the tank is maintained at 65ºC rather than allowing it to drift back to
ambient.
1)
Sleep Mode, and
2)
Low Light Mode.
Sleep Mode can be set to 2 hours or 4 hours.
Sleep Mode is indicated by the Sleep symbol on the LCD.
Low Light Mode is indicated by the Low Light symbol on the LCD.
When the unit actually enters energy saver mode it is indicated by the Sleep Mode Indicator on the LCD.
SW1
SW2
SW3
SW4
SW5
SW6
SW7
SW8
NU
NU
NU
ON
OFF
ON
ON
ON
Where NU = Not Used (either position is acceptable)
Operating Procedures
(setting the controls)
The user interface is shown below.
retha@chilli-b.co.za
www.chilli-b.co.za | 012 809 4026
antonius@chilli-b.co.za
www.chilli-b.co.za | 012 809 4026
