Installation instructions & user manual
804544UK V2.03 Oct 2018 - Zip Econoboil
Technical support
Tel: 0345 6 005 005 Email: service@zipindustries.co.uk www.zipwater.co.uk
06
Technical specification
Installation instructions
Min / Max water supply pressure
Econoboil.........................................0.07 MPa (0.7 bar) - 0.5 MPa (5.0 bar)
WARNING !
If the incoming mains water pressure is likely to exceed 0.5 MPa (5.0 bar), a 0.35 MPa
(3.5 bar) pressure limiting valve must be installed in the cold water supply line.
Note
Optional Water Block is recommended to be fitted in the water supply line to minimise the potential
damage in the event of leakage, call Zip on 0345 6 005 005
!
Before You Begin
Locate the paper mounting-hole template packed with the Econoboil. (Also see
page 12).
Read the installation and operating instructions completely.
Decide whether to install with concealed or exposed plumbing connections.
Concealed connections are preferred for superior appearance.
Step 1 – Positioning
• Position the Econoboil so the nozzle will drain on to a draining board or
drip tray.
• Position the base of the tap nozzle to be not less than 280mm (nominally
360mm) above the draining board (height should be increased only if
essential for filling larger vessels).
• Provide clearance for service access of not less than 150mm top, 65
mm left, 20mm right.
• Mark corner positions for the Econoboil on the wall in order to position the
paper mounting-hole template.
Step 2 – Fastening
• Position mounting-hole template on wall and drill holes where shown.
• Drill holes for water inlet and vent outlet if rear access is intended.
• Install plumbing and wiring and prepare pipe ends as shown.
• Remove cover fastening screws from Econoboil and lift off cover.
• Screw Econoboil chassis to the wall using screws or bolts suited to the
wall, (supplied).
• Fasteners must be able to support the product weight when full, (see
Technical specification, above).
45mm
Elbow
Inlet clearance
Cold
inlet
Vent
outlet
Inlet
position
Vent
position
Product
code
Tank
size
(litres)
Heat up
time
(Inlet
15°C)
Heat up
time
(Inlet
10°C)
Rated voltage and
power
Dimensions
(mm)
W x D x H
Filled
weight(Kg)
303542
3.0
16mins
17mins
220-240V, 50Hz, 1400W 289 x 180 x 431
12.5
305542
5.0
16mins
17mins
220-240V, 50Hz, 2200W 318 x 198 x 465
16.5
