16
INSTALLATION INSTRUCTIONS & USER MANUAL
T210012 V1.00 FEB 2018 -ZIP HYDROCHILL 10
TECHNICAL SUPPORT
TEL: 0345 6 005 005 EMAIL: SERVICE@ZIPINDUSTRIES .CO.UK
WWW.ZIPWATER.CO.UK
INSTALLATION
Installing the CO
2
cylinder
(sparkling models)
(Not supplied by Zip)
Fig 12
Fig 13
Fig 14
1
2
4
3
• The area must be properly
ventilated.
• The CO
2
cylinder must be used
in a vertical position, and must be
restrained safely, to prevent it falling
over.
• Double check that the cylinder
is the correct CO
2
gas for this
application (see below).
• Once the unit is connected to the
mains water and electricity, you can
install the E290 food-grade carbon
dioxide (CO
2
) cylinder.
• Attach the regulator & CO
2
pipe to
the cylinder valve.
• Insert the CO
2
inlet tube from the
cylinder into the fitting (
1
). Be sure
to remove any air in the hydraulic
circuit and to achieve a good level
of carbonation, before opening the
valve on the CO
2
cylinder pull the
ring of the remote safety valve (
2
)
until water comes out of it.
• When the cylinder is open, to
increase or decrease the level
of carbonation of the water, you
need to adjust the screw (
3
) on the
pressure reducer.
• Turning it clockwise increases the
level of carbonation.
• We recommend that you do not
exceed 4 bar of pressure (
4
).
• To achieve a good level of
carbonation, you need to wait until
the water is sufficiently cold – i.e. at
least one hour after installation.
!
WARNING
(also see precautions
pages 2 & 3)