Page 17 of 24
HydroTap Installation and Operating Instructions_Commercial_BCH 4in1_BH 3in1_October 2012_V1.05
Setting the Energy Saver Timer
Normal Operation Set Time
To change time, press either Mode
<
or Mode < button until Set Time is on the display screen.
Press
<
Adjust button to increase time or < Adjust button to decrease time. Time increases
or decreases in increments of one minute. Hold the Adjust buttons down for rapid increases or
decreases. The time will be displayed in 24Hr mode.
Set Day
Press either Mode
<
or Mode < button until Set Day is displayed.
Press
<
Adjust or < Adjust to select day.
Filter Life
( factory set at 6000ltrs )
Press either Mode
<
or Mode < button until Filter Life is displayed.
Press
<
Adjust button to increase Filter Life or < Adjust button to decrease Filter Life.
Filter Life increases in 1000 Ltr increments to a maximum of 10000ltrs.
Reset Litres Filtered
This function is to reset the Filter Change display after a filter has reached the end of its life (refer
to “Replace Filter Instructions” section of this document).
Mode Plus Button
Mode Minus Button
Adjust Plus Button
Adjust Minus Button
Note:
Mode buttons
change the
screen options
Adjust buttons
select the
screen options
8. Avoid touching the filter “O” rings and filter opening as this may cause
bacterial contamination of the cartridge.
9. Align cartridge tabs with the slots on the under-side of the filter head.
10. Slide cartridge upward into head and rotate left to right until it stops.
11. Locate the filter flush hose situated behind the filter cartridge and run to a
container ready for flushing. Open the flush hose tap lever. On the control
panel press adjust
>
, this will start the water flushing the cartridge.
Allow at least 7.5 Ltrs of water to run through to activate the filter and
then press adjust
>
to stop the flow.
12. Isolate the filter flush stop cock and re-fit behind the filter cartridge.
13. Wipe up any spills and dispose of spent filter cartridge and packaging
thoughtfully.
14. Scroll through the menu to “Litres Filtered”, press adjust
>
to reset litre
counter. Press adjust
>
and it asks “are you sure”. Press adjust
>
again
to lock in the command.
15. Scroll through the menu to “Filter Used (Days)”, press adjust
>
to reset
the timer. Press adjust
>
and it asks “are you sure”. Press adjust
>
again to lock in the command. After approx 10 seconds it will default to
the selected mode.
16. Close the door to secure the appliance.
Warning:
If the Zip HydroTap is
switched off for a long period of
time (e.g. More than a weekend),
run water through the chilled water
outlet for at least 5 minutes before
consumption.
Internal Filter Replacement
(Continued)
