HydroTap Installation and Operating Instructions_Commercial_BCH 4in1_BH 3in1_October 2012_V1.05
Page 20 of 24
3-in-1 Installation Options
4-in-1 Installation Options
NOTE:
The Venturi connection for the 3-in-1 Mixer tap is located on the Left Hand
side of the undersink unit.
The Mixer tap may be fitted (as shown above) to supply Cold or Hot water to
one or two sinks.
The HydroTap may be fitted to supply filtered Boiling water to any one sink or
may be fitted with a Font kit, when a sink is not available. The Font must be
connected to a suitable drain.
NOTE:
The Venturi connection for the 4-in-1 Mixer tap is located at the back of the
undersink unit. Connections to the Venturi should be made prior to fitting the
undersink unit in place
The Mixer tap may be fitted (as shown below) to supply Cold or Hot water to
one or two sinks.
The HydroTap may be fitted to supply filtered Boiling or Chilled water to any
one sink or may be fitted with a Font kit, when a sink is not available. The Font
must be connected to a suitable drain.
