PACKAGING CONTENT
- Power adapter 115/230 AC to 12V DC
- Ethernet cable
- Antenna* for Z-wave network (*optional)
1.1. HOW TO FIND THE SERIAL NUMBER
Your serial number is located on the left side of the Zipabox2, make a note of it
as it will be required when registering your server online.
1.2. CONNECT TO ETHERNET
Connect your Zipabox2 to your broadband router via Ethernet cable.
The Ethernet port is located on the top of the Zipabox2.
Zipabox2 queries your DHCP server for an IP address. If you do not have a
DHCP server in your local network, after 60 seconds Zipabox2 will auto-
configure itself with a link-local IPv4 address (in 169.254.0.0/16 range).
1.3. CONNECT TO WiFi
The unit can also be connected to the WiFi. To connect to the WiFi:
1. Make sure the unit is powered off (power it off if necessary)
2. Connect power cable
3. Hold Button 1 until all LEDs start flashing sequentially in green color
1.0. | INSTALLATION
01
Serial
number
02
Antenna*
(865-926MHz)
03
USB
port
*optional models
*
04
Ethernet
port
05
Power
input
02
03 04 05
01
*
The unit is now in WiFi AP (access point) mode. Use your mobile phone or PC to
connect to this AP. AP name is in this form: Zipabox2-<serial number>.
To connect the unit to your WiFi network:
- connect to the AP named Zipabox2-<serial number of Zipabox2>
- open http://192.168.43.1 in your browser
- select the desired AP name, input password
The unit will now try to connect to selected WiFi AP. If it succeeds connecting,
LED will light up green (red means that there was a connection problem). In
this case, reset the unit and try again, making sure the password is correct for
the selected WiFi network. Reset the unit by holding Button 2 for 4 seconds.
