TRANSPORT
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
25
ZI-BES350Y
1.
Loosen oil drain plug on the rear of the engine.
2.
Open oil tank cap . Collect the draining oil in a collecting container and
dispose of it properly!
3.
Tighten oil drain plug again after emptying.
4.
Top up with fresh oil via the filling opening (K) (see section Checking the
engine oil level).
Only use high-quality engine oil, e.g. SAE30, 15W40 or similar!
Cleaning the air filter
A contaminated air filter can contribute to problems starting the machine,
loss of performance during operation and shorten engine life.
Zipper Machines does not accept any liability for engine damage caused
by failure to clean the air filter regularly.
To clean the air filter, first loosen the wing nut on the air filter housing,
remove the cover (foam filter element) and remove the air filter cassette
(paper filter element). Clean both elements mechanically with a soft
brush.
If only the air filter cassette is to be cleaned, blow a dry jet of
compressed air from the inside against the filter until all dust has been
removed.
An air filter change is necessary when:
The engine power drops and the fuel consumption increases at the
same time.
the oil consumption increases
the starting of the engine becomes more difficult
Cleaning the spark plug
1.
Pull out the spark plug cap and remove impurities from the outside of the spark plug.
2.
Unscrew the spark plug using the spark plug wrench.
3.
Check the ceramic insulation, clean the electrodes (metal tips) and check the distance
between the contacts. It should be 0.7 to 0.8 mm.
4.
Reinstall the cleaned (or replaced) spark plug and replace the spark plug cap.
18
TRANSPORT
W A R N I N G
Never lift or transport the machine with the engine running!
Lifting and transporting with separate devices
N O T I C E
There are two persons required to lift and park the machine on another transporting devices.
- one person to operate the hoist and one person to keep the machine in balance.
Dismount the throttle on the handle. Drain fuel, engine oil and transmission oil.
Then pack the machine into the packing box, lift it onto the transport trolley
with forklift trucks, then fix it in place to avoid displacement and machine
damage.
