STORAGE
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
26
ZI-BES350Y
19
STORAGE
If the machine is not used for a longer period of time (>30 days):
1.
Empty the oil tanks or fuel tank.
2.
Remove the spark plug and pour a few drops of engine oil into the cylinder. Using a
rope starter, turn the engine a few times so that the oil is well distributed inside the
cylinder. Clean the spark plug and replace it.
3.
Cover the cooled machine and store it out of the reach of children and unauthorised
persons in a well-ventilated, dry and frost-free environment.
20
RECYCLING
Do not dispose of your machine in residual waste. Contact your local authorities for
information on available disposal options. If you buy a new vibratory plate or
equivalent from your dealer, he is obliged in certain countries to dispose of your old
machine properly.
21
TROUBLESHOOTING
W A R N I N G
Hot surfaces and rotating machine parts while the engine is running can cause
serious injury or even death. Always stop the machine before carrying out
troubleshooting work and secure it against unintentional restarting.
Failure
Possible root-cause / measure
If the engine does not want to
start:
Check the ON/OFF switch if it is „ON“
Check the fuel cock if on
Check for fuel, check the fuel pipe for leaks
Cold start / warm start difference
Spark plug
Carburator or air filter polluted.
When the engine stops:
Check fuel supply chain.
Check motor oil level.
Check air filter.
When engine output drops:
Check the air filter.
Diamond cutting disc vibrates
Nut/flange not tightened/ set cor-rectly
tighten
Nut flange is dirty
clean and tighten
Cutting disc not mounted correctly
check
Diamond cutting disc does not
cut
Cutter disc is dull
renew
Wrong cutter disc
choose suitable one
