OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
28
ZI-RAM80C
13
OPERATION
Secure the working area properly before you start to compact.
Never attempt to put the machine into service without having read the security, setup and
operation instruction in this manual and having performed all necessary checks and tasks
described in the chapter before.
The correct level of humidity is decisive for good compacting results. Humidity is a kind of
lubrication helping to compress particles more together.
Compacting an underground without any humidity is not possible. Too high levels of humidity
make compacting ineffective as well and might cause the machine to stall.
Do not use the tamping rammer at hard undergrounds, frozen underground or rocky underground.
Start and stop
Cold start
Open fuel cock (K) and (c) entirely
Set Choke lever (8) to „CLOSE“
Bring throttle lever (A) into middle speed position (middle position)
Main switch (3) ON
Recoil start: Grip the handle (7) of the recoil starter, pull it back slightly until you feel resistance,
let it roll back, pull it out briskly in one pull entirely.
When the engine started, open the choke (8), adjust throttle (A) in order that the engine runs idle.
Let the engine run in idle for at least some minutes.
To start to compact bring the throttle lever (A) cautious into max. speed position!
