TROUBLE SHOOTING
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
34
ZI-RAM80C
Storage
If you store the tamping rammer for longer than 30 days:
Drain fuel from fuel tank, fuel pipe.
Remove spark plug, drip some drops of oil into the plug hole into the cylinder housing. Fasten the
spark plug back again and push the recoil starter (Attention Main switch off) with the effect that
the engine cock moves up and down and the oil gets distributed along the combustion chamber
walls.
Cover the tamping rammer with a clean cloth and store it in a clean and dry place.
Disposal
DO NOT DISPOSE your ZI-RAM80C in residual waste. Contact your local authorities
about the available disposal possibilities. Drain the remaining petrol, motor oil and
gear oil before disposing the machine and dispose these separately in an
environmentally sound way. A non proper disposal of the machine can lead to
contamination of soil and water which in turn will affect you in the long run as it
gets through soil and water into the food chain.
15
TROUBLE SHOOTING
problem
Reason /solution
If the engine does not start:
Check the ON/OFF switch if it is „ON“
Check the fuel cock if on
Check for fuel, check the fuel pipe for leaks
Cold start / warm start difference
Spark plug polluted, contacts defect
Carburator or air filter polluted.
If the engine does not stop:
Check fuel supply chain.
Check motor oil level.
Check air filter.
When engine output drops:
Check the air filter.
Check fuel supply chain for damages/leaks
If the machine does not work
freely:
Check bottom side of compactor plate for built up
compacted debris.