OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
23
ZI-ABH1500D / ZI-ABH1700D
12.2
Operation
12.2.1
Insert chisel
Clean the tool shank of deposits and grease it lightly one.
The clamp bolt from the tool shaft pull and turn 90 ° clockwise
Set the tool and rotate the clamp bolt back to 90 degrees and
let it snap back into the tool shank.
Check by pulling the tool if the tool is firmly held in place.
Tool shank should always be greased before insertion
.
When removing the tool. Follow the above procedure in reverse
order.
12.2.2
Switch on
Press the Power push button to the start the engine and set the stroke to move.
By pressing the locking button can be switched to continuous operation.