ASSEMBLY
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
27
ZI-RPE160C
3.
Plate extension assembly (if used)
Fix the plate extension (1) on both side of the
machine with three screws/washer (3) onto
the base plate (2).
4.
Rubber mat assembly (if used)
Attach the rubber mat (1) by means of
fixation bar (2) and four screws/washers (2)
onto the machine no both sides and attach
the rubber mat extension (4) if used by
means of one screw / washer (5) each side
onto the plate extension (4).
15.1
Checklist before each use
N O T I C E
The use of paint thinners, petrol, aggressive chemicals or abrasives leads to
material damage to the surfaces! Therefore use only mild detergents for cleaning!
Clean the machine and remove dirt and dust if necessary.
If the air filter is dirty, blow the filter cartridge from the inside by moving a jet of
dry compressed air up and down. Continue until all dust has been removed.
Replace the air filter with a new one if necessary.
Check the carburettor for external dirt and dust and clean it with dry compressed
air if necessary.
Check the nuts and bolts for tightness. (Screws or bolts loosened by vibrations can
lead to accidents!)
15.1.1
Checking the engine oil level
N O T I C E
Too low oil level will damage the engine and shorten the life of the machine.
Therefore, check the engine oil level before every start and top up the engine oil if
necessary.
1.
To check the engine oil level, place the machine on a
safe, level surface. Switch off the engine and allow the
machine to stand for ten minutes so that the circulating
oil can collect in the oil pan.
2.
Unscrew the oil dipstick and wipe with a clean, lint-free
cloth or a non-fibrous paper towel.
