OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
30
ZI-HET40V-AKKU
Battery state of charge:
Press the button on the battery to check the state
of charge at the state of charge indicator LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must be
recharged. If none of the LEDs light up after the
button is pressed, the battery is faulty and must be
replaced.
W O R K I N S T R U C T I O N S
Check that all parts are firmly attached and obviously undamaged.
Check that there are no leaks.
Never work on unstable ground!
Never work while standing on a ladder!
Do not bend too far forwards when working!
Use the power tool only when the weather conditions and terrain are favourable!
Stand with both legs firmly on the ground.
Beware of obstructions in the working area.
When working, always hold the power tool with both hands!
After use:
Always switch the motor off before you put the power tool down! When the On/Off switch is
released, the saw chain continue running briefly.
Stop the motor.
Wait until all rotating parts have come to a standstill.
Remove the battery.
Place sheath on cutting mechanism.
Leave power tool to cool down.
13.4
Basic working technique
Look over the working area and remove any obstructions.
Before starting work, check the safety of the power tool.
Pick up the power tool in both hands.
Switch the machine on before starting the cut.
Apply a uniform pressure to the machine, however not
excessive force.
If possible, place the unit's tree claw on the branch which
is to be sawn.
Operate the saw at a maximum angle of 60°. Never cut a
branch directly about the head!!
Start at the bottom of the trunk and work upwards.
For an accurate cut thick branches should be sawn in 2
steps:
o
Saw upwards into the branch 1/3 of the branch
diameter (1.).
o
A little further up the branch saw through the branch
from top to bottom (2.).
