INHALT / INDEX / INDICE/
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
21
ZI-MOS145A / ZI-MOS4TA
Refuel only outdoors or in a well ventilated area.
Avoid contact with skin and clothes (fire hazard).
Check after refuelling tank cap and check for leaks.
Start the engine at least 3 meters from the tank location.
Spilled fuel is wipe immediately.
Work attentively, safety conscious and always be fully aware safe stand when working! Caution
on uneven work surfaces and work surfaces with a slope!
Never cutting:
-
above hip height
-
on a ladder
-
on trees
Regular breaks reduce the security risk to loss of control due to fatigue. Change the working
position over again.
Avoid abnormal posture.
At idle, the blade should not rotate!
The maximum shaft speed must not exceed the specified speed. Checked settings!
No other person shall remain within 15m!
This distance also adhere to things! Danger of damage!
Solid objects, stones, metal parts, or the like can be thrown out - risk of injury!
Use personal safety equipment: ear protectors, safety goggles, safety shoes and safety helmet
when working with the machine
Never leave the machine running unattended! Before leaving the working area switch the
machine off and wait until the machine stops.
Switch off the machine before maintenance or adjustment.
Storage always with an empty tank in a safe place.
Do not grab in the cutting tool while it is rotating.
Take care that you do not get under the cutting tool!
Always use the correct cutting tool for the work to be done.
Do not operate in an enclosed or confined areas.
Exhaust contains poisonous carbon monoxide. The exposure can cause unconsciousness and
death.
Before the start, after the failure or shock, be sure to check the device and make sure that it is
in good condition.
Wear firm gloves when you use the brush cutter or if you install or remove the cutting blade.
TRANSPORT NOTES:
Switch off the engine
Fit the blade guard
Secure the machine
Empty tank completely, avoid fuel spillage
To avoid damage to the device never drag but always lift correctly.
STORAGE NOTES:
Remove and clean thread head and cutter blade
Fit the blade guard
Clean the machine and dry
Empty Tank completely, avoid fuel spillage
Store in a dry, out of reach of children place, well packaged (protection against cuts)
