INHALT / INDEX / INDICE/
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
28
ZI-MOS145A / ZI-MOS4TA
15
TROUBLE SHOOTING
Trouble
Possible cause
Solution
Engine does not start
Incorrect starting sequence
Observe the correct starting
sequence
Dirty air filter
Clean/replace air filter
No fuel supply
Refuel
Fault in the fuel line
Check the fuel line for kinks or
damages
Engine flooded.
Screw off, clean and dry the spark
plug. Then pull the cranking rope
several times and reinstall the spark
plug
Spark plug connector not
placed on.
Place on the spark plug connector
No ignition spark
Clean/replace spark plug
Check ignition cable
Engine starts and is stalled
immediately
Incorrect idle adjustment
Contact customer service
Machine works with
interruptions
Carburetor incorrectly
adjusted
Contact customer service
Spark plug fouled
Clean/replace spark plug
Check spark plug connector
Smoke
Incorrect fuel mixture
(2-stroke engine)
Use correct fuel mixture
Carburetor incorrectly
adjusted
Contact customer service
Machine does not work with
full performance
Machine overloaded
Too much pressure
Cutting material too tough
Dirty air filter
Clean/replace air filter
Carburetor incorrectly
adjusted
Contact customer service
Blade rotates at idling
Idle speed too high
Adjust a lower idle speed
Blade rotates but has no
power
Choke is ON
Set Choke to OFF
Bad cuts
Foreign material wrapped,
grass around the sheet
Shut machine off, wait until cutter
stands still, remove the winded up
material
Long grass
Remove material
Blunt saw blade
Sharpen or replace saw blade
NOTICE
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the problem.