OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
18
ZI-COM2-8
12
OPERATION
Please check the product contents immediately after receipt for any eventual transport damage or
missing parts. Claims from transport damage or missing parts must be placed immediately after
initial machine receipt and unpacking before putting the machine into operation. Please understand
that later claims cannot be accepted anymore.
12.1
Operation instructions
Device to be operated in a perfect state only. Inspect the device visually every time it is to be used.
Check in particular the safety equipment, electrical controls, electric cables and screwed connection for
damage and if tightened properly. Replace any damaged parts before operating the device.
WARNING
Perform all machine settings with the machine being
disconnected from the power supply!
NOTICE
The machine should be set up near the working consumer. Avoid long air lines
and long supply lines (extensions).
Make sure the intake air is dry and dust-free.
Do not set up the machine in damp or wet areas.
The machine must be operated on firm, level ground
When removing the hose coupling, hold the coupling piece of the hose is by
hand. So the injury from rebounding hose is avoided
12.2
Operation
Switch on:
Push the ON-OFF-switch “1”
Switch off:
Push the ON-OFF-switch “0”
Output:
To connect a device place the union joint into the
coupling. The sleeve will go to starting position
automatically. To disconnect pull the sleeve backwards
and remove the hose.
Adapter set:
Connect the desired adapter as shown on the right
picture.
