OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
24
ZI-STE6700DH & ZI-STE7500DSH
Assembly wheel shaft
Fix the wheel shaft to the frame with 2 clamps
and 4 screws.
Assembly wheels
Place the wheel (1) on the stub shaft (3), add
washers (4) and secure against axial movement
by means of the cotter pin (3). Carry out that
assembly steps on both sides.
Assembly Feet
Attach the rubber feet (1) to the stand feet (29)
and slide the stand foot (2) into the holder on
the frame and secure it with the screw (3).
Connecting the battery
The battery is attached to the frame by means
of a holding bracket (1) or can be removed
after loosening.
Clamp the (+) pole (3) red to the battery using
a screw connection, then clamp the (-) pole (2)
black to the battery using a screw connection.
Put both pole covers (2a, 3a) back in place to
protect the two poles.
ZI-STE7500DSH:
The machine is delivered fully assembled. There is no further assembly necessary, except connection of
the battery.
13
OPERATION
This power unit is designed exclusively for operating electric devices whose max. Performance within
the performance specifications of the generator. A higher starting current of inductive loads must be
considered.
13.1
Checklist before each use
13.1.1
Checking the engine oil level
NOTICE
Too low an oil level will damage the engine and shorten the life of the machine.
Therefore, check the engine oil level before every start and top up the engine oil if
necessary.
NOTICE
Engine oil and fuels are toxic and must not be released into the
environment! Follow the instructions of the supplier and, if necessary,
contact your local authorities for information on proper disposal.
