TROUBLE
SHOOTING
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
26
ZI-HB305
26
Storage
Never store the machine outdoors!
Storage permitted only at temperatures b 5 ° and + 40 ° Celsius, at + 40 ° Celsius the
humidity must not be higher than 60%. Store in a dry and clean place.
Cleaning
After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do not
remove them by hand (cutting injury!). Remove dust as well.
N O T I C E
The usage of certain solutions containing ingredients damaging metal surfaces as
well as the use of scrubbing agents will damage the machine surface!
Clean the machine surface with a wet cloth soaked in a mild solution
Disposal
Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer
for a replacement unit, the latter is obliged to exchange your old.
15
TROUBLE SHOOTING
Disconnect the machine from the power supply prior to any checks performed at the ma-chine
itself!
Trouble
Possible cause
Solution
Machine does not
start.
On-Switch not
pushed
Check if ON-Switch is pushed
Damaged or
incorrect
connected
extension cable
Check extension cable with other machine.
Voltage supply
(Voltage,
frequency).
Power supply to the requirements of technical data
operating voltage.
Malfunction of
ON/OFF switch
This should be checked by an electrician and
replaced if defective.
Material kickback
Cutting depth to
high
Reduce cutting depth
Bad surface
condition after
operating
- Wrong adjusted
blade,
- blunt blade
Exchange / re-adjust blade
MANY MALFUNCTIONS AND DEFECTS CAN BE AVOIDED BY LETTING THE MACHINE BE
CONNECTED TO YOUR POWER SUPPLY BY A CERTIFIED ELECTRICIAN.
N O T I C E
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
